Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) 5 + 2 Error Code
What the 5 + 2 code means
On Lennox G61MPV furnaces with the SureLight control, flash code 5 + 2 means the control failed its self-check — an internal control error. The G61MPV manual notes the control will restart if the error recovers.
Likely causes
- Failed SureLight control board
- Power surge or transient
How to fix it — step by step
- Turn power off for 60 seconds and back on once
- If 5 + 2 returns, do not keep cycling power
- Call a technician to confirm and replace the control board → Shop the control board at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the control board.
Parts that commonly fix the 5 + 2 code
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Lennox Furnace G61MPV — SureLight single-LED paired-flash (X + Y) error codes
See all Lennox G61MPV — SureLight single-LED paired-flash (X + Y) codes & guides →