Furnace Error Codes — All Brands
Browse 229 furnace error codes & guides across 8 brands. Pick your brand below to see its full list, or start with the ones people look up most.
Shop Furnace parts at RepairClinic or Amazon
By brand
- Bryant Furnace - 26 guides
- Carrier Furnace - 27 guides
- Goodman Furnace - 24 guides
- Lennox Furnace - 40 guides
- Payne Furnace - 25 guides
- Rheem Furnace - 28 guides
- Trane Furnace - 40 guides
- York Furnace - 19 guides
Most common furnace codes
- Bryant 10.1 — L1 polarity fault on Bryant furnaces with a 3-digit status display, such as the 926TC and 912SE. The LED flashes rapidly and the display…
- Carrier 10.1 — L1 polarity fault on Carrier furnaces with the 3-digit status display, such as the 58SC0B/58SC1B. The LED flashes rapidly and the display…
- Goodman 1 flash — System lockout because ignition retries were exceeded on Goodman GMES96-series furnaces with the red LED diagnostic board. The furnace…
- Lennox 1 + 2 — On Lennox G61MPV furnaces with the SureLight control, flash code 1 + 2 means low flame current in run mode — the flame signal is weak while…
- Payne 10.1 — L1 polarity fault on the Payne PG80MSU (80% furnace with 3-digit display). The LED flashes rapidly and the display reads 10.1: the polarity…
- Rheem 0 — Standby on Rheem furnaces with the 7-segment diagnostic display (including R95P models). This is a normal status, not a fault — the furnace…
- Trane 1 flash — On Trane two-stage furnaces (XV80, XV90, XV95, XL80, XL90 families, *UD2/*DD2) the green LED counts the fault: flame sensed when no flame…
- York 1 red flash — Flame was sensed when there was no call for heat on York furnaces with the red/green/amber LED control. The control runs the inducer and…
- Bryant 11 — No previous code. On Bryant furnaces with the two-digit LED status code system, code 11 means no fault is stored in the control's memory…
- Carrier 11 — No previous code. On Carrier furnaces with the two-digit LED status code system, code 11 means no fault is stored in the control's memory…
- Goodman 10 flashes — Open fuse on Goodman GMES96-series furnaces. The low-voltage fuse on the control board has opened, usually because of a short in the…
- Lennox 1 + 3 — On Lennox G61MPV furnaces with the SureLight control, flash code 1 + 3 means flame sensed out of sequence — a flame signal is still present…