York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) 1 red flash
What this problem usually means
Flame was sensed when there was no call for heat on York furnaces with the red/green/amber LED control. The control runs the inducer and blower with this fault; a gas valve that leaks through or is slow closing would typically cause it.
Likely causes
- gas valve leaking through → Shop the gas valve at RepairClinic
- gas valve slow to close
- flame sensor fault → Shop the flame sensor at RepairClinic
How to fix it — step by step
- Turn the furnace power switch off and do not keep resetting it
- If you smell gas, leave the house and call your gas utility from outside
- Note the code for the technician
- Call a licensed HVAC technician before using the furnace again
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the gas valve.
Shop the gas valve at RepairClinic or Amazon
Also tied to this fault: flame sensor - Shop at RepairClinic or Amazon
Parts that commonly fix it
- gas valve - Shop at RepairClinic or Amazon
- flame sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) problems
- 10 red flashes
- 11 red flashes
- 12 red flashes
- 2 red flashes
- 3 red flashes
- 4 amber flashes
- 4 red flashes
- 5 red flashes
- 6 red flashes
- 7 red flashes
- 8 red flashes
- 9 red flashes
See all York UPG LED control — single/two-stage (PT9-era, red/green/amber LED) codes & guides →