Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) 1 flash

What it should look like on your machine

then it repeats

1 flash - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

On Trane two-stage furnaces (XV80, XV90, XV95, XL80, XL90 families, *UD2/*DD2) the green LED counts the fault: flame sensed when no flame should be present — a flame signal exists while the gas valve should be closed. Note this count differs from single-stage Trane boards.

Likely causes

  1. Gas valve leaking or stuck open
  2. Shorted flame sensor wiring → Shop the flame sensor at RepairClinic
  3. Failed control board → Shop the control board at RepairClinic

How to fix it — step by step

  1. Turn furnace power off and close the gas shutoff to the furnace
  2. Do not keep resetting the furnace
  3. If you smell gas, leave the house and call the gas utility
  4. Call a technician to test the gas valve and flame-sense circuit → Shop the gas valve at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) problems

See all Trane Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) codes & guides →