Rheem Furnace Seven-segment display — R95P platform 0 Error Code
What the 0 code means
Standby on Rheem furnaces with the 7-segment diagnostic display (including R95P models). This is a normal status, not a fault — the furnace is powered and waiting for a thermostat call.
Likely causes
- no call for heat from the thermostat
- thermostat set to Off or satisfied
How to fix it — step by step
- Check the thermostat is set to Heat and above room temperature
- Check thermostat batteries if fitted
- Check the furnace power switch and breaker are on
- If there is a heat call and the display still shows 0, call a technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the 0 code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Rheem Furnace Seven-segment display — R95P platform error codes
See all Rheem Seven-segment display — R95P platform codes & guides →