Goodman Furnace GMES96 — LED flash-count control 1 flash
What it should look like on your machine
then it repeats
1 flash - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
System lockout because ignition retries were exceeded on Goodman GMES96-series furnaces with the red LED diagnostic board. The furnace tried to light, failed to prove flame, and shut down for safety.
Likely causes
- failed ignition attempts
- no gas supply to the burners
- faulty hot surface igniter → Shop the hot surface igniter at RepairClinic
- dirty or failed flame sensor → Shop the flame sensor at RepairClinic
How to fix it — step by step
- Check the thermostat is set to Heat and the furnace power switch and breaker are on
- Confirm the manual gas shutoff valve near the furnace is open (handle parallel to the pipe)
- Turn power off for 30 seconds, then back on, and allow one retry cycle
- Do not keep resetting a furnace that repeatedly fails to light
- If it locks out again, call a licensed HVAC technician and note the code
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the hot surface igniter.
Shop the hot surface igniter at RepairClinic or Amazon
Also tied to this fault: flame sensor - Shop at RepairClinic or Amazon; gas valve - Shop at RepairClinic or Amazon
Parts that commonly fix it
- hot surface igniter - Shop at RepairClinic or Amazon
- flame sensor - Shop at RepairClinic or Amazon
- gas valve - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Goodman Furnace GMES96 — LED flash-count control problems
- 10 flashes
- 11 flashes
- 12 flashes
- 2 flashes
- 3 flashes
- 4 flashes
- 5 flashes
- 6 flashes
- 7 flashes
- 8 flashes
- 9 flashes
- Rapid flash
See all Goodman GMES96 — LED flash-count control codes & guides →