Goodman Furnace GMES96 — LED flash-count control 10 flashes
What it should look like on your machine
then it repeats
10 flashes - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Open fuse on Goodman GMES96-series furnaces. The low-voltage fuse on the control board has opened, usually because of a short in the low-voltage wiring.
Likely causes
- blown control board fuse → Shop the control board fuse at RepairClinic
- short in thermostat or low-voltage wiring
- shorted component in the control circuit
How to fix it — step by step
- Turn the thermostat to Off
- Check the furnace power switch and breaker are on
- Do not repeatedly replace the fuse — a repeat blow means a short
- Call a licensed HVAC technician to find the short and replace the fuse
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the control board fuse.
Shop the control board fuse at RepairClinic or Amazon
Also tied to this fault: control board - Shop at RepairClinic or Amazon
Parts that commonly fix it
- control board fuse - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Goodman Furnace GMES96 — LED flash-count control problems
- 11 flashes
- 12 flashes
- 2 flashes
- 3 flashes
- 4 flashes
- 5 flashes
- 6 flashes
- 7 flashes
- 8 flashes
- 9 flashes
- Rapid flash
- 1 flash
See all Goodman GMES96 — LED flash-count control codes & guides →