Bosch Oven 300 / 500 / 800 Series built-in wall ovens E106 Error Code
What the E106 code means
The cavity 1 door latch does not lock on 300, 500 and 800 Series built-in wall ovens (E206 is the same fault for cavity 2), so modes that need a locked door, such as self-clean, cannot run.
Likely causes
- failed door latch motor or assembly → Shop the door latch assembly at RepairClinic
- door not fully closed or obstructed
- latch switch or wiring fault
How to fix it — step by step
- Open and firmly close the door, checking racks or cookware are not pushing it open
- Turn the oven off at the breaker for 30 seconds and try again
- If the latch still will not lock, book a technician for the latch assembly
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the door latch assembly.
Parts that commonly fix the E106 code
- door latch assembly - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Bosch manual is on Bosch's support site — you'll need your model number.
Find your model number on the frame inside the oven door or behind the storage drawer. It's the key to the right manual pages and the right parts.
Related Bosch Oven 300 / 500 / 800 Series built-in wall ovens error codes
See all Bosch 300 / 500 / 800 Series built-in wall ovens codes & guides →