Bosch Oven 300 / 500 / 800 Series built-in wall ovens E000 Error Code
What the E000 code means
Wrong module combination on 300, 500 and 800 Series built-in wall ovens: the control module and user interface are mismatched, usually after a board replacement, and no operation is possible until the option code is set correctly.
Likely causes
- control module and user interface mismatched → Shop the control module at RepairClinic
- option code not set after replacing a board
- wrong replacement board fitted
How to fix it — step by step
- Turn the oven off at the breaker for 30 seconds and restore power
- If the code appeared after a repair, tell the installer - the option code must be set in service mode
- Book a technician if the code persists; board configuration is not a homeowner job
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the control module.
Shop the control module at RepairClinic or Amazon
Also tied to this fault: user interface - Shop at RepairClinic or Amazon
Parts that commonly fix the E000 code
- control module - Shop at RepairClinic or Amazon
- user interface - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Bosch manual is on Bosch's support site — you'll need your model number.
Find your model number on the frame inside the oven door or behind the storage drawer. It's the key to the right manual pages and the right parts.
Related Bosch Oven 300 / 500 / 800 Series built-in wall ovens error codes
See all Bosch 300 / 500 / 800 Series built-in wall ovens codes & guides →