Bosch Oven 300 / 500 / 800 Series built-in wall ovens E010 Error Code
What the E010 code means
Data memory error in the user interface on 300, 500 and 800 Series built-in wall ovens: a memory check or write failed and all heating elements are disabled until the error clears at start-up.
Likely causes
- failed data memory in the user interface
- user interface electronics fault
- power interruption during a memory write
How to fix it — step by step
- Turn the oven off at the breaker for 30 seconds and restore power to restart it
- If the code returns at start-up, stop using the oven
- Book a technician - Bosch's service information points to replacing the user interface → Shop the user interface at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the user interface.
Parts that commonly fix the E010 code
- user interface - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Bosch manual is on Bosch's support site — you'll need your model number.
Find your model number on the frame inside the oven door or behind the storage drawer. It's the key to the right manual pages and the right parts.
Related Bosch Oven 300 / 500 / 800 Series built-in wall ovens error codes
See all Bosch 300 / 500 / 800 Series built-in wall ovens codes & guides →