Bosch Oven 300 / 500 / 800 Series built-in wall ovens E104 Error Code
What the E104 code means
The cavity 1 temperature sensor is shorted on 300, 500 and 800 Series built-in wall ovens (E204 is the same fault for cavity 2). Heating stops and the cooling fan runs at high speed until good readings return.
Likely causes
- temperature sensor shorted to ground → Shop the temperature sensor at RepairClinic
- damaged or pinched sensor harness
- failed temperature sensor
How to fix it — step by step
- Turn the oven off at the breaker for 30 seconds and restore power
- If the code returns, stop using the oven
- Book a technician to test the sensor and harness
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the temperature sensor.
Shop the temperature sensor at RepairClinic or Amazon
Also tied to this fault: wire harness - Shop at RepairClinic or Amazon
Parts that commonly fix the E104 code
- temperature sensor - Shop at RepairClinic or Amazon
- wire harness - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Bosch manual is on Bosch's support site — you'll need your model number.
Find your model number on the frame inside the oven door or behind the storage drawer. It's the key to the right manual pages and the right parts.
Related Bosch Oven 300 / 500 / 800 Series built-in wall ovens error codes
See all Bosch 300 / 500 / 800 Series built-in wall ovens codes & guides →