York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) Slow green flash
What this problem usually means
Normal operation with no call for heat on York furnaces with the red/green/amber LED control (including PT9 series). This is a standby status, not a fault.
Likely causes
- thermostat satisfied or set to Off
- no heat call present
How to fix it — step by step
- Check the thermostat is set to Heat and above room temperature if you want heat
- Check thermostat batteries if fitted
- No repair is needed if the furnace heats when called
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) problems
- Steady on red
- 1 red flash
- 10 red flashes
- 11 red flashes
- 12 red flashes
- 2 red flashes
- 3 red flashes
- 4 amber flashes
- 4 red flashes
- 5 red flashes
- 6 red flashes
- 7 red flashes
See all York UPG LED control — single/two-stage (PT9-era, red/green/amber LED) codes & guides →