York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) 4 red flashes
What this problem usually means
A primary or auxiliary limit switch has opened on York furnaces with the red/green/amber LED control. The control runs the blower and inducer; the manual lists airflow and firing problems as causes.
Likely causes
- dirty filter
- improperly sized duct system
- incorrect blower speed setting
- incorrect firing rate
- faulty blower motor → Shop the blower motor at RepairClinic
How to fix it — step by step
- Turn the thermostat down and let the furnace cool
- Replace the air filter if it is dirty or clogged
- Open all supply registers and make sure return vents are not blocked by furniture
- Restore the heat call and watch whether the code returns
- If the limit code repeats, stop and call a licensed HVAC technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the limit switch.
Shop the limit switch at RepairClinic or Amazon
Also tied to this fault: blower motor - Shop at RepairClinic or Amazon
Parts that commonly fix it
- limit switch - Shop at RepairClinic or Amazon
- blower motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) problems
- 5 red flashes
- 6 red flashes
- 7 red flashes
- 8 red flashes
- 9 red flashes
- Rapid amber flash
- Rapid red flash
- Slow amber flash
- Slow green flash
- Steady on red
- 1 red flash
- 10 red flashes
See all York UPG LED control — single/two-stage (PT9-era, red/green/amber LED) codes & guides →