York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) Steady on red
What this problem usually means
Control failure on York furnaces with the red/green/amber LED control. If the failure is internal to the control, the light stays on continuously and the manual says the entire control should be replaced.
Likely causes
- failed control board → Shop the control board at RepairClinic
- internal control fault
How to fix it — step by step
- Turn power off at the furnace switch for 30 seconds, then back on
- Try one heat call and note whether the LED stays steady on
- Do not keep cycling power if it stays on
- Call a licensed HVAC technician — the control is not field repairable
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the control board.
Parts that commonly fix it
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) problems
- 1 red flash
- 10 red flashes
- 11 red flashes
- 12 red flashes
- 2 red flashes
- 3 red flashes
- 4 amber flashes
- 4 red flashes
- 5 red flashes
- 6 red flashes
- 7 red flashes
- 8 red flashes
See all York UPG LED control — single/two-stage (PT9-era, red/green/amber LED) codes & guides →