York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) 4 amber flashes
What this problem usually means
The control board is receiving a Y (cooling) signal from the thermostat without a G (fan) signal on York furnaces with the red/green/amber LED control, indicating improper thermostat wiring.
Likely causes
- thermostat wiring error
- missing G wire connection
How to fix it — step by step
- Check the thermostat is set to Heat, not Cool, if you are calling for heat
- Note the pattern for the technician
- Do not rewire the thermostat unless you are confident and power is off
- Call a technician if the wiring needs correction
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) problems
- 4 red flashes
- 5 red flashes
- 6 red flashes
- 7 red flashes
- 8 red flashes
- 9 red flashes
- Rapid amber flash
- Rapid red flash
- Slow amber flash
- Slow green flash
- Steady on red
- 1 red flash
See all York UPG LED control — single/two-stage (PT9-era, red/green/amber LED) codes & guides →