York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) Rapid amber flash
What this problem usually means
Flame sense current is below 1.5 microamps on York furnaces with the red/green/amber LED control. The manual advises checking and cleaning the flame sensor and checking for proper gas flow.
Likely causes
- dirty flame sensor
- mislocated flame sensor rod
- low gas flow
How to fix it — step by step
- Replace the air filter if it is dirty
- Turn power off for 30 seconds, then back on, and try one heat call
- Do not keep resetting if heating becomes unreliable
- Call a technician to clean the flame sensor and check gas flow → Shop the flame sensor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the flame sensor.
Parts that commonly fix it
- flame sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) problems
- Rapid red flash
- Slow amber flash
- Slow green flash
- Steady on red
- 1 red flash
- 10 red flashes
- 11 red flashes
- 12 red flashes
- 2 red flashes
- 3 red flashes
- 4 amber flashes
- 4 red flashes
See all York UPG LED control — single/two-stage (PT9-era, red/green/amber LED) codes & guides →