York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) 9 red flashes

What this problem usually means

Reversed line voltage polarity or a grounding problem on York furnaces with the red/green/amber LED control. Both heating and cooling operation are affected.

Likely causes

  1. reversed line polarity at the furnace or branch
  2. poor furnace grounding
  3. flame probe shorted to chassis

How to fix it — step by step

  1. Turn the furnace power switch off
  2. Do not attempt line-voltage wiring repairs yourself
  3. Note the code for the technician
  4. Call a licensed HVAC technician or electrician to check polarity and grounding

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related York Furnace UPG LED control — single/two-stage (PT9-era, red/green/amber LED) problems

See all York UPG LED control — single/two-stage (PT9-era, red/green/amber LED) codes & guides →