Rheem Furnace Seven-segment display — R95P platform 10 Error Code
What the 10 code means
One-hour lockout on Rheem furnaces with the 7-segment diagnostic display. The control locked out after repeated ignition or flame failures and will retry after the lockout period.
Likely causes
- repeated failed ignition (shown with code 11)
- repeated flame loss (shown with code 13)
- unexpected flame lockout (shown with code 14)
How to fix it — step by step
- Check the thermostat is set to Heat and the furnace power switch and breaker are on
- Confirm the manual gas shutoff valve near the furnace is open (handle parallel to the pipe)
- Turn power off for 30 seconds, then back on, and allow one retry cycle
- Do not keep resetting a furnace that repeatedly fails to light
- If it locks out again, call a licensed HVAC technician and note the code
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the hot surface igniter.
Shop the hot surface igniter at RepairClinic or Amazon
Also tied to this fault: flame sensor - Shop at RepairClinic or Amazon
Parts that commonly fix the 10 code
- hot surface igniter - Shop at RepairClinic or Amazon
- flame sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Rheem Furnace Seven-segment display — R95P platform error codes
See all Rheem Seven-segment display — R95P platform codes & guides →