Rheem Furnace Seven-segment display — R95P platform 14 Error Code
What the 14 code means
Unexpected flame on Rheem furnaces with the 7-segment diagnostic display. Flame is sensed when the gas valve should be closed — shut down and call for service.
Likely causes
- gas valve leaking through or slow to close → Shop the gas valve at RepairClinic
- flame sensor or wiring fault → Shop the flame sensor at RepairClinic
How to fix it — step by step
- Turn the furnace power switch off and do not reset it repeatedly
- If you smell gas, leave the house and call your gas utility from outside
- Note the code for the technician
- Call a licensed HVAC technician before using the furnace again
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the gas valve.
Shop the gas valve at RepairClinic or Amazon
Also tied to this fault: flame sensor - Shop at RepairClinic or Amazon
Parts that commonly fix the 14 code
- gas valve - Shop at RepairClinic or Amazon
- flame sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Rheem Furnace Seven-segment display — R95P platform error codes
See all Rheem Seven-segment display — R95P platform codes & guides →