Rheem Furnace Seven-segment display — R95P platform 13 Error Code
What the 13 code means
Flame lost on Rheem furnaces with the 7-segment diagnostic display. Flame was established and then lost during the heating cycle; five losses in a row cause a one-hour lockout with code 10.
Likely causes
- dirty flame sensor → Shop the flame sensor at RepairClinic
- low gas pressure
- faulty gas valve → Shop the gas valve at RepairClinic
- interrupted gas supply
How to fix it — step by step
- Check the thermostat is set to Heat and the furnace power switch and breaker are on
- Confirm the manual gas shutoff valve near the furnace is open (handle parallel to the pipe)
- Turn power off for 30 seconds, then back on, and allow one retry cycle
- Do not keep resetting a furnace that repeatedly fails to light
- If it locks out again, call a licensed HVAC technician and note the code
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the flame sensor.
Shop the flame sensor at RepairClinic or Amazon
Also tied to this fault: gas valve - Shop at RepairClinic or Amazon
Parts that commonly fix the 13 code
- flame sensor - Shop at RepairClinic or Amazon
- gas valve - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Rheem Furnace Seven-segment display — R95P platform error codes
See all Rheem Seven-segment display — R95P platform codes & guides →