Rheem Furnace Seven-segment display — R95P platform 12 Error Code
What the 12 code means
Low flame sense on Rheem furnaces with the 7-segment diagnostic display. Flame is present but the flame signal is too weak.
Likely causes
- dirty or oxidized flame sensor
- weak burner flame
- low gas pressure
How to fix it — step by step
- Replace the air filter if it is dirty
- Turn power off for 30 seconds, then back on, and try one heat call
- Do not keep resetting if the code returns
- Call a technician to clean the flame sensor and check gas pressure → Shop the flame sensor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the flame sensor.
Parts that commonly fix the 12 code
- flame sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Rheem Furnace Seven-segment display — R95P platform error codes
See all Rheem Seven-segment display — R95P platform codes & guides →