Polaris Pool cleaner Floating excessively

What this problem usually means

The cleaner does not stay on the pool surface/floor, or is floating excessively instead of hugging the bottom.

Likely causes

  1. Air trapped inside the cleaner housing
  2. The filter canister is full or dirty

How to fix it — step by step

  1. Remove the cleaner from the pool and re-submerge it following the Install and Submerge procedure, shaking it to release trapped air
  2. Dispose of debris and thoroughly clean the filter canister with mild soap and a soft brush, then re-submerge the cleaner

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Polaris Pool cleaner problems

See all Polaris pool cleaner codes & guides →