Polaris Pool cleaner Not climbing walls
What this problem usually means
The cleaner runs on the floor but is not climbing the walls.
Likely causes
- The filter canister is full or dirty
- Track treads worn down
- Pool chemistry out of balance
- Cleaner set to Floor Only mode (cordless models)
How to fix it — step by step
- Dispose of debris and thoroughly clean the filter canister with mild soap and a soft brush, then re-submerge the cleaner
- Check the track wear indicators and replace worn tracks → Shop the tracks at Amazon
- Confirm appropriate pool chemistry with your pool service professional; do not leave the cleaner in the pool during chemical treatments
- On models with cleaning modes, select Floor/Wall mode instead of Floor Only
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the tracks.
Parts that commonly fix it
- tracks - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.