Polaris Pool cleaner Error 10
What this problem usually means
Control-box display error 10: communication error between the control box and the cleaner.
Likely causes
- Floating cable not properly connected to the control box
- Corrosion or bent pins at the cable connection point
How to fix it — step by step
- Turn cleaner power off and on again to reset
- Check the floating cable connection to the control box
- Check for corrosion or bent pins at the connection point
- If this does not resolve the problem, contact your local retailer for a diagnostic review or call customer service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.