Polaris Pool cleaner Cable tangling in the pool

What this problem usually means

The floating cable tangles or coils in the pool while the cleaner runs, limiting its coverage.

Likely causes

  1. Cable is not spread evenly in the water
  2. Cable stored too tightly wrapped or coiled, so it holds a memory

How to fix it — step by step

  1. Verify the floating cable enters the water near the middle of the pool length
  2. Spread all of the floating cable carefully in the pool, ensuring there are no kinks or coils
  3. Ensure the cable is not too tightly wrapped or coiled when storing
  4. If the problem persists, lay the cable straight in the sun to relax it and remove kinks

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Polaris Pool cleaner problems

See all Polaris pool cleaner codes & guides →