Polaris Pool cleaner 1 flash
What it should look like on your machine
then it repeats
1 flash - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Status indicator flashing 1 flash / 1 second pause: communication error between the control box and the cleaner. On connected models the same alert appears in the iAquaLink app.
Likely causes
- Cleaner cable not properly connected to the control box
- Something interfering with the cable connection area
How to fix it — step by step
- Disconnect and reconnect the cleaner
- Check that the cable is properly connected to the control box
- Check that nothing is interfering with the cable connection area
- After fixing, press any key on the control box (except the power button) to delete the error code, or press Clear Error in the iAquaLink app
- If this does not resolve the problem, contact your local retailer for a diagnostic review or call customer service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.