Polaris Pool cleaner 3 flashes
What it should look like on your machine
then it repeats
3 flashes - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Status indicator flashing 3 flashes / 1 second pause: cleaner out of the water — the cleaner detects that it is not submerged.
Likely causes
- The cleaner was started out of the water, or air is trapped in the housing
- Filter clogged, reducing the cleaner's ability to stay down
How to fix it — step by step
- Turn the cleaner off
- Clean the filter thoroughly
- Put it back in the water, shaking to release the air bubbles
- Restart the cycle
- After fixing, press any key on the control box (except the power button) to delete the error code, or press Clear Error in the iAquaLink app
- If this does not resolve the problem, contact your local retailer for a diagnostic review or call customer service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.