Polaris Pool cleaner Cleaner not moving
What this problem usually means
The cleaner does not move at all when a cycle should be running.
Likely causes
- Not connected to electricity — the outlet the control box is connected to is not supplying power
- Cycle not started
- Reset needed
How to fix it — step by step
- Check that the outlet to which the control box is connected is receiving electricity
- Press the Start button to initiate a cleaning cycle
- Disconnect the unit power and reconnect after 20 seconds to reset
- If the problem is not resolved, contact your local retailer for a diagnostic review or Technical Support
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.