Polaris Pool cleaner Error 8
What this problem usually means
Control-box display error 8: cleaner out of the water — the cleaner detects that it is not submerged.
Likely causes
- The cleaner was started out of the water or has climbed/beached out of the water
- Air trapped inside the cleaner housing
How to fix it — step by step
- Turn cleaner power off
- Submerge the cleaner following the correct procedure, shaking it to release air bubbles
- Restart the cycle
- If this does not resolve the problem, contact your local retailer for a diagnostic review or call customer service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.