Kenmore Washer 796 Series (LG-Built) Front-Load tE Error Code
What the tE code means
Heating sensor (thermistor) error on Kenmore 796-series (LG-built) front-load washers: the water temperature sensor reading is out of range.
Likely causes
- Failed thermistor
- Loose or damaged thermistor wiring
- Control board fault
How to fix it — step by step
- Unplug the washer and restart a cycle to see if tE clears
- Do not keep running heated cycles if tE returns immediately
- Have the thermistor and its wiring tested with a multimeter → Shop the thermistor at RepairClinic
- Replace the thermistor if its resistance is out of range
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the thermistor.
Parts that commonly fix the tE code
- thermistor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Kenmore Washer 796 Series (LG-Built) Front-Load error codes
See all Kenmore 796 Series (LG-Built) Front-Load codes & guides →