Kenmore Washer 796 Series (LG-Built) Front-Load OE Error Code
What the OE code means
Slow drain on Kenmore 796-series (LG-built) front-load washers: the washer is not draining, or is draining too slowly.
Likely causes
- Kinked or clogged drain hose
- Clogged drain pump filter
- Standpipe or house drain blocked
- Failed drain pump
How to fix it — step by step
- Check the drain hose for kinks and clogs
- Clean the drain pump filter at the front of the washer → Shop the drain pump at RepairClinic
- Make sure the standpipe or house drain is clear
- Restart the cycle and replace the drain pump if it does not run
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drain pump.
Parts that commonly fix the OE code
- drain pump - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Kenmore Washer 796 Series (LG-Built) Front-Load error codes
See all Kenmore 796 Series (LG-Built) Front-Load codes & guides →