Kenmore Washer 796 Series (LG-Built) Front-Load IE Error Code
What the IE code means
Inlet water supply error on Kenmore 796-series (LG-built) front-load washers: the expected water level is not reached in 8 minutes, or the preset level is not reached in 25 minutes.
Likely causes
- Water supply faucets closed or partly open
- Kinked inlet hoses or clogged inlet screens
- Low water pressure
- Failed inlet water valve assembly
How to fix it — step by step
- Make sure both water supply faucets are fully open
- Straighten the inlet hoses and clean the inlet screens
- Check that house water pressure is adequate
- Restart the cycle; if IE returns with good supply, the inlet valve assembly or control board needs service → Shop the water inlet valve at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve.
Parts that commonly fix the IE code
- water inlet valve - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Kenmore Washer 796 Series (LG-Built) Front-Load error codes
See all Kenmore 796 Series (LG-Built) Front-Load codes & guides →