Kenmore Washer 796 Series (LG-Built) Front-Load PE Error Code
What the PE code means
Water level sensor failure on Kenmore 796-series (LG-built) front-load washers: the control cannot read the water level correctly.
Likely causes
- Loose or damaged sensor wiring
- Blocked or disconnected pressure hose
- Failed water level (pressure) sensor → Shop the water level sensor at RepairClinic
How to fix it — step by step
- Unplug the washer for a few minutes, then restart a cycle
- Check for obvious hose or wiring damage only if you can do so safely
- Restart and watch whether the fill level is normal
- Call a technician if PE returns, as the level sensor needs testing or replacement
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the water level sensor.
Parts that commonly fix the PE code
- water level sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Kenmore Washer 796 Series (LG-Built) Front-Load error codes
See all Kenmore 796 Series (LG-Built) Front-Load codes & guides →