Kenmore Washer 796 Series (LG-Built) Front-Load FE Error Code
What the FE code means
Water overflow error on Kenmore 796-series (LG-built) front-load washers: the water level is too high.
Likely causes
- Water inlet valve stuck open
- Water level sensor failure → Shop the water level sensor at RepairClinic
- Too much detergent creating excess suds read as high level
How to fix it — step by step
- Turn off the water faucets if the washer keeps filling
- Unplug the washer and let it drain or pump out
- Restart with less detergent and check the fill stops normally
- Call for service if it overfills again, as the inlet valve or level sensor is faulty → Shop the water inlet valve at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve.
Shop the water inlet valve at RepairClinic or Amazon
Also tied to this fault: water level sensor - Shop at RepairClinic or Amazon
Parts that commonly fix the FE code
- water inlet valve - Shop at RepairClinic or Amazon
- water level sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Kenmore Washer 796 Series (LG-Built) Front-Load error codes
See all Kenmore 796 Series (LG-Built) Front-Load codes & guides →