iRobot Robot vacuum Roomba 400 Series Uh-oh + no beeps
What this problem usually means
Roomba plays the 'uh-oh' tone with no beeps after it: a side wheel is stuck or is not touching the ground.
Likely causes
- A drive wheel is jammed with debris
- The robot is high-centred so a wheel hangs free
- A wheel drop switch is faulty
How to fix it — step by step
- Spin both drive wheels by hand to check for debris or binding
- Set the robot flat on the floor and restart the mission
- If one wheel does not spring back when pressed, the wheel module or its drop switch needs service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.