iRobot Robot vacuum Roomba 400 Series Circle dance (spins in circles, backs up, stops)
What this problem usually means
The classic 'circle dance': Roomba spins in a tight circle or arc, sometimes backing up, then stops. On the 400 series this is usually a wheel tachometer sensor problem, not a motor problem: the robot halts the healthy wheel and oscillates the suspect wheel trying to clear the sensor.
Likely causes
- Dirt, debris or grease film covering a wheel tachometer sensor's IR lenses (most common)
- A failed wheel tachometer IR emitter or receiver
- A dirty 'dump' (cliff/bumper) sensor - on Discovery models a backward circle points to these, a forward circle to the wheel tach
How to fix it — step by step
- Run the built-in diagnostic tests: the tachometer test (Tests 9/10 in the Discovery diagnostics) identifies the faulty wheel
- Blow compressed air into the wheel sensor area and clean the slotted disc and sensor lenses
- If cleaning does not restore the tach signal, open the wheel assembly and clean the emitter and detector lenses directly
- Replace the wheel module if the tachometer sensor has failed
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Drive wheel module.
Parts that commonly fix it
- Drive wheel module - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.