iRobot Robot vacuum Roomba 400 Series Uh-oh + 5 beeps
What it should sound like on your machine
then it repeats
5 beeps - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Roomba plays 'uh-oh' then 5 beeps: the cliff sensors are obstructed.
Likely causes
- Dust film over the cliff sensor windows
- Debris stuck in the sensor recesses under the bumper
- A failing cliff sensor emitter or receiver
How to fix it — step by step
- Wipe all four cliff sensor windows under the front bumper → Shop the cliff sensor at Amazon
- Blow compressed air into the sensor pockets to clear internal dust
- If the error persists on clean, light-coloured flooring, a cliff sensor needs replacement
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Cliff sensor.
Parts that commonly fix it
- Cliff sensor - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.