iRobot Robot vacuum Roomba 400 Series Uh-oh + 1 beep
What it should sound like on your machine
then it repeats
1 beep - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Roomba plays 'uh-oh' then 1 beep: the main brushes are stalled and cannot turn.
Likely causes
- Hair and debris wound around the brush ends and bearings
- Debris packed inside the brush gearbox (Cleaning Head Module)
- A failed brush motor or worn gearbox gears
How to fix it — step by step
- Remove the brushes and clean hair from the ends and the yellow bearings
- Run the robot briefly without the brushes fitted: if the error clears, the brushes or bearings were the drag
- Open the brush gearbox and clean out packed debris; if the gears are worn or the motor does not run on direct power, replace the Cleaning Head Module → Shop the cleaning head module (chm) at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Cleaning Head Module (CHM).
Parts that commonly fix it
- Cleaning Head Module (CHM) - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.