iRobot Robot vacuum Roomba 400 Series Uh-oh + 6 beeps
What it should sound like on your machine
then it repeats
6 beeps - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Roomba plays 'uh-oh' then 6 beeps: the wheel drop sensors are overloaded, meaning a wheel is stuck in the down (dropped) position.
Likely causes
- A wheel drop switch stuck or contaminated
- Debris in the wheel well holding the wheel down
- A broken wheel suspension or switch
How to fix it — step by step
- Press each wheel up and down to confirm it springs back freely
- Clean around the wheel wells and drop switches
- Replace the wheel module if the drop switch does not recover
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Drive wheel module.
Parts that commonly fix it
- Drive wheel module - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.