iRobot Robot vacuum Roomba 400 Series Uh-oh + 9 beeps
What it should sound like on your machine
then it repeats
9 beeps - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Roomba plays 'uh-oh' then 9 beeps: the wheel drop sensors failed the start-up check.
Likely causes
- A failed wheel drop sensor or switch
- Wiring damage to a wheel module
- Debris preventing a wheel from sitting correctly at start-up
How to fix it — step by step
- Set the robot on a flat floor, press each wheel in and release it, then restart
- Clean the wheel wells
- Replace the wheel module whose drop sensor fails the start-up test
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Drive wheel module.
Parts that commonly fix it
- Drive wheel module - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.