iRobot Roomba 400 Series Common Problems
Find your problem in the list below. Each page explains the most likely causes, step-by-step checks you can do yourself, when to call a pro, and the parts that commonly resolve it. 11 problems covered.
Shop iRobot Roomba 400 Series parts at Amazon
Not sure of the code? Tap along with it
If your iRobot Robot vacuum blinks or beeps a pattern instead of showing a code, tap the button in time with each blink or beep. A pause longer than a second and a half starts a new group - we will match the rhythm to a code.
Your rhythm: -
- "Ehh" sound — Roomba makes an 'ehh' sound: the cliff sensors are dirty or need repair.
- Circle dance (spins in circles, backs up, stops) — The classic 'circle dance': Roomba spins in a tight circle or arc, sometimes backing up, then stops. On the 400 series this is usually a…
- Uh-oh + 1 beep — Roomba plays 'uh-oh' then 1 beep: the main brushes are stalled and cannot turn.
- Uh-oh + 10 beeps — Roomba plays 'uh-oh' then 10 beeps: the bumper is not registering obstacles.
- Uh-oh + 2 beeps — Roomba plays 'uh-oh' then 2 beeps: the side brush is stalled.
- Uh-oh + 3 beeps — Roomba plays 'uh-oh' then 3 beeps: the vacuum (blower) motor is stalled.
- Uh-oh + 4 beeps — Roomba plays 'uh-oh' then 4 beeps: a drive (wheel) motor is stalled.
- Uh-oh + 5 beeps — Roomba plays 'uh-oh' then 5 beeps: the cliff sensors are obstructed.
- Uh-oh + 6 beeps — Roomba plays 'uh-oh' then 6 beeps: the wheel drop sensors are overloaded, meaning a wheel is stuck in the down (dropped) position.
- Uh-oh + 9 beeps — Roomba plays 'uh-oh' then 9 beeps: the wheel drop sensors failed the start-up check.
- Uh-oh + no beeps — Roomba plays the 'uh-oh' tone with no beeps after it: a side wheel is stuck or is not touching the ground.