iRobot Robot vacuum Roomba 400 Series Uh-oh + 10 beeps
What it should sound like on your machine
then it repeats
10 beeps - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Roomba plays 'uh-oh' then 10 beeps: the bumper is not registering obstacles.
Likely causes
- A failed or dirty bumper sensor (IR emitter/receiver pair)
- Debris inside the bumper sensor assembly
- A disconnected bumper sensor harness
How to fix it — step by step
- Clean the bumper sensor area and check the bumper moves freely
- Open the bumper assembly and clean the IR emitter and receiver lenses
- Replace the bumper sensor pair if one side does not respond in the built-in tests → Shop the bumper sensor pair at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Bumper sensor pair.
Parts that commonly fix it
- Bumper sensor pair - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.