Whirlpool Washer Front-Load (Tech Sheet W11156990) F1 E2 Error Code
What the F1 E2 code means
Motor control error: the motor control unit has an over- or under-voltage fault or has reset repeatedly.
Likely causes
- Household voltage too high or too low
- Failed motor control unit (MCU)
- Loose motor wiring harness
How to fix it — step by step
- Unplug the washer for 5 minutes and restart
- Check the outlet is not on a tripped breaker and try a different cycle
- If the code returns, call for service to test the motor control and motor
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the motor control board.
Shop the motor control board at RepairClinic or Amazon
Also tied to this fault: drive motor - Shop at RepairClinic or Amazon
Parts that commonly fix the F1 E2 code
- motor control board - Shop at RepairClinic or Amazon
- drive motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Whirlpool Washer Front-Load (Tech Sheet W11156990) error codes
See all Whirlpool Front-Load (Tech Sheet W11156990) codes & guides →