Whirlpool Washer Front-Load (Tech Sheet W11156990) F3 E6 Error Code
What the F3 E6 code means
Accelerometer error: the control cannot get a valid signal from the accelerometer that monitors tub movement.
Likely causes
- Failed accelerometer → Shop the accelerometer at RepairClinic
- Failed main control (ACU)
- Loose wiring to the sensor
How to fix it — step by step
- Unplug the washer for 5 minutes and restart
- Make sure the washer is level and the load is balanced, then retry
- If the code returns, call for service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the accelerometer.
Shop the accelerometer at RepairClinic or Amazon
Also tied to this fault: main control board - Shop at RepairClinic or Amazon
Parts that commonly fix the F3 E6 code
- accelerometer - Shop at RepairClinic or Amazon
- main control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Whirlpool Washer Front-Load (Tech Sheet W11156990) error codes
See all Whirlpool Front-Load (Tech Sheet W11156990) codes & guides →