Whirlpool Washer Front-Load (Tech Sheet W11156990) F3 E1 Error Code
What the F3 E1 code means
Water level pressure sensor error: the pressure sensor signal is missing or out of range.
Likely causes
- Pressure hose pinched, kinked, plugged or leaking air
- Blocked tub pressure port
- Failed pressure sensor / water level sensor → Shop the water level pressure sensor at RepairClinic
How to fix it — step by step
- Unplug the washer for 5 minutes and restart a cycle
- Check you are not overloading or creating excess suds that confuse sensing
- If the code returns, call for service to check the pressure hose and sensor → Shop the pressure hose at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the water level pressure sensor.
Shop the water level pressure sensor at RepairClinic or Amazon
Also tied to this fault: pressure hose - Shop at RepairClinic or Amazon
Parts that commonly fix the F3 E1 code
- water level pressure sensor - Shop at RepairClinic or Amazon
- pressure hose - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Whirlpool Washer Front-Load (Tech Sheet W11156990) error codes
See all Whirlpool Front-Load (Tech Sheet W11156990) codes & guides →