Whirlpool Washer Front-Load (Tech Sheet W11156990) F3 E2 Error Code
What the F3 E2 code means
Temperature sensor error: the wash/inlet water temperature sensor (NTC thermistor) is open or shorted.
Likely causes
- Failed temperature sensor/thermistor → Shop the temperature sensor at RepairClinic
- Loose or damaged sensor wiring
- Failed main control
How to fix it — step by step
- Unplug the washer for 5 minutes and restart
- If the code returns on every cycle, call for service to test and replace the sensor
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the temperature sensor.
Parts that commonly fix the F3 E2 code
- temperature sensor - Shop at RepairClinic or Amazon
Before you buy: check the temperature sensor first
Test: Disconnect the temperature sensor and measure its resistance, comparing it to the temperature where the sensor sits.
A good one reads: 35.9 kΩ at 32°F (0°C) and 9.7 kΩ at 86°F (30°C) (Whirlpool Duet component testing table, Job Aid 8178076). Resistance should fall smoothly as temperature rises.
Test values from idoc.pub documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Whirlpool Washer Front-Load (Tech Sheet W11156990) error codes
See all Whirlpool Front-Load (Tech Sheet W11156990) codes & guides →