Whirlpool Front-Load (Tech Sheet W11156990) Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 14 codes covered.
Shop Whirlpool Front-Load (Tech Sheet W11156990) parts at RepairClinic or Amazon
- F0 E2 — Oversuds: the washer detected excessive suds and is running a suds-reduction routine.
- F0 E4 — High temperature error in the wash cycle: the wash water temperature is higher than expected.
- F0 E5 — Off-balance load: the load is unbalanced or too large for the washer to spin safely.
- F1 E1 — Main control board failure: a main relay is open or shorted, or the central control has an internal/EEPROM communication error.
- F1 E2 — Motor control error: the motor control unit has an over- or under-voltage fault or has reset repeatedly.
- F3 E1 — Water level pressure sensor error: the pressure sensor signal is missing or out of range.
- F3 E2 — Temperature sensor error: the wash/inlet water temperature sensor (NTC thermistor) is open or shorted.
- F3 E6 — Accelerometer error: the control cannot get a valid signal from the accelerometer that monitors tub movement.
- F4 E1 — Wash heater relay error: the control cannot detect the expected temperature rise from the wash heater.
- F4 E2 — Heating timeout: the wash water did not heat to the target temperature in the allowed time.
- F5 E3 — Unlock failure: the door or lid lock will not unlock at the end of the cycle.
- F5 E4 — Door not open error: the door was not opened between cycles, so the control does not register a fresh cycle.
- F6 E1 — Communication error: the main control has lost communication with the user interface (HMI).
- F6 E3 — Communication error: the main control has lost communication with the motor control unit.