Whirlpool Washer Front-Load (Tech Sheet W11156990) F4 E2 Error Code

What the F4 E2 code means

Heating timeout: the wash water did not heat to the target temperature in the allowed time.

Likely causes

  1. Failed wash heating element → Shop the wash heating element at RepairClinic
  2. Failed temperature sensor → Shop the temperature sensor at RepairClinic
  3. Very cold incoming water slowing heating

How to fix it — step by step

  1. Check the home water supply is on and the inlet hose is not kinked
  2. Unplug for 5 minutes and retry a heated cycle
  3. If the code returns, call for service to test the heating element

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the F4 E2 code

Before you buy: check the temperature sensor first

Test: Disconnect the temperature sensor and measure its resistance, comparing it to the temperature where the sensor sits.

A good one reads: 35.9 kΩ at 32°F (0°C) and 9.7 kΩ at 86°F (30°C) (Whirlpool Duet component testing table, Job Aid 8178076). Resistance should fall smoothly as temperature rises.

Test values from idoc.pub documentation - confirm against your model's own tech sheet.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.

Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.

Related Whirlpool Washer Front-Load (Tech Sheet W11156990) error codes

See all Whirlpool Front-Load (Tech Sheet W11156990) codes & guides →