Whirlpool 4-digit F/E-code models (PartSelect chart) Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 19 codes covered.
Shop Whirlpool 4-digit F/E-code models (PartSelect chart) parts at RepairClinic or Amazon
- F1 E0 — EEPROM communication error: the oven control board cannot communicate with its memory. Official Whirlpool tech sheets list the same code as…
- F1 E1 — An electronic control fault: PartSelect lists it as an EEPROM checksum error, and Whirlpool tech sheets list it as an internal board…
- F1 E2 — UL A/D error on the oven control board - an internal analogue-to-digital conversion fault in the electronic control.
- F1 E3 — The wiring harness cavity size does not match the value stored in the control - the harness jumpers tell the board a different oven size…
- F1 E6 — Latch signal mismatch error on the oven control board - the latch signal the board receives does not match what it expects.
- F2 E0 — Shorted touch pad (keypad), in the PartSelect 4-digit chart.
- F2 E1 — Touch pad (keypad) cable unplugged, in the PartSelect 4-digit chart.
- F2 E5 — Cancel key line open: the control cannot read the Cancel key circuit on the touch pad.
- F3 E0 — The main oven temperature sensor is open or shorted (Whirlpool tech sheet wording). PartSelect's older table describes F3 E0 specifically…
- F3 E1 — An oven temperature sensor fault in the F3 E family: PartSelect groups all F3 E-codes as an oven temperature sensor (RTD) or warming drawer…
- F3 E2 — Oven temperature over 575F in Bake mode (too hot), in the older 4-digit tables.
- F3 E3 — Oven too hot in Clean mode - the newer companion to F3 E2 (too hot in Bake) and to the classic F2 code.
- F4 E1 — A meat probe defect: the control sees a problem with the meat probe, its receptacle, or the probe circuit.
- F5 E0 — Door and latch switches do not agree (Clean mode on tech sheets): for example the door reads open while the latch reads locked.
- F5 E1 — The self-clean door latch is not operating / will not lock: the door is not locked about a minute after the lock (self-clean) function…
- F5 E2 — A latch fault during Clean: the self-clean latch faulted while a clean cycle was running (grouped with F5 E0 / E1 as a door switch defect…
- F6 E0 — Return line not connected: the control loses the switch pulse return line and shows the code within about 60 seconds of power-up. On…
- F6 E1 — Over-temperature: Whirlpool sources list F6 E1 as oven over-temperature when heating / over-temperature in Cook, set when the oven reaches…
- F7 E1 — The common switch wire is defective: the common wire to the latch switch and door switch is shorted (to chassis ground or neutral on the…