Whirlpool Oven 4-digit F/E-code models (PartSelect chart) F3 E3 Error Code

What the F3 E3 code means

Oven too hot in Clean mode - the newer companion to F3 E2 (too hot in Bake) and to the classic F2 code.

Likely causes

  1. Drifted oven temperature sensor reading low, so the control overheats the cavity → Shop the oven temperature sensor at RepairClinic
  2. Welded bake / broil relay on the control board → Shop the control board at RepairClinic
  3. Door lock fault during self-clean

How to fix it — step by step

  1. Press Cancel, cancel self-clean, and let the oven cool for at least an hour
  2. Do not run self-clean again until the cause is fixed
  3. If the code returns in normal Bake use, schedule service for sensor and relay testing

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the F3 E3 code

Before you buy: check the oven temperature sensor first

Test: Unplug the range and measure the oven temperature sensor's resistance at the sensor connector or the control check points in the tech sheet.

A good one reads: 1080 Ω at 21°C / 70°F, rising to 1654 Ω at 177°C / 350°F — add about 2 Ω per 1°F above room temperature (Whirlpool tech sheet 8303103 / W10201489A). If the resistance is not valid, replace the sensor.

Test values from forum.appliancepartspros.com documentation - confirm against your model's own tech sheet.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.

Find your model number on the frame inside the oven door or behind the storage drawer. It's the key to the right manual pages and the right parts.

Related Whirlpool Oven 4-digit F/E-code models (PartSelect chart) error codes

See all Whirlpool 4-digit F/E-code models (PartSelect chart) codes & guides →